Blue Flower

 

Over time, it is obvious that your hardwood floor will become scratched and dull from general wear and tear.   In case your hardwood floor is fitted with polyurethane, it can normally be recoated without the requirement of sanding the whole floor at first.   Recoating http://twodudescleaningservice.com/about-us/  is fundamental if the floor is gently scratched and worn, the finish has not worn, and it doesn't have a gathering of wax or different chemicals.   These will bring about adhesion issues and make the floor reject the new finish which can lead to detaching and shedding.   These will cause adhesion problems and cause the floor to reject the new finish which can cause peeling and flaking.   Recoating is an easy process that entails deep cleaning and scuffing the timber surfaces uppermost layer of the finish.   Then, a new fresh layer of finish is applied.   Recoating will invigorate the polish and remove any slight staining that has yet to infiltrate the timber.   It invigorates your wood floor and prolongs the life of its protective finish layers.   It is prudent that you recoat your floor while it looks great.   This will extend the life of the floor and decrease the number of times it has to be refinished.

 

Recoating a hardwood floor should not be confounded with refinishing a hardwood floor.   The last includes widely sanding the floor to uncover the wood, imperative when there are profound scratches, harm or if the floor has been waxed.   To check whether your floor can be recoated, you should do a small patch test in an inconspicuous area.   It is advisable to do the testing along a wall where cleaners may have collected.   Thoroughly clean the area with the use of wood floor cleaner and then lightly sand with fine sandpaper.   You should then wipe away all traces of dust.   At that point apply polyurethane floor finish to the area and wait for 24 hours.   The finish should be smooth, not swollen, or with an orange shell touch.   Scratch the surface with modest pressure with the use of a coin and it should not flake or peel away.   In the likelihood that the surface fails these tests, the floor will require being broadly sanded and revamped.

 

For recoating twodudescleaningservice.com/about-us to happen on your hardwood floor, it needs to initially be moderately sanded with a screen disk.   From that point, the floor ought to be cleared and vacuumed to take out the wood dust.   You ought to then moist a tack cloth with clean mineral spirits and brush it over the floor to collect any fine dirt and oily left overs.   At the time of fitting the finish, it is recommended you make use of a similar finish as was used to guarantee compatibility.   In case the current coating is not compatible with the fresh one, there will be issues like shedding that can happen.